Element at home on the 22nd, not the 28th as probable, skilled packaging & best looking than pictured. Fee including shipping was skilled and go including the intention of it was the release M2 w/trail 3/8" end mill holder not on Chinese backorder, I now be inflicted including a full set of effectively obsolete M2 style holders. It is extremely water supply balanced to 5500 rpm (peak alacrity I run) including a Weldon release end, dual flute on tempered aluminum (WWII Vintage). Total run out is 0.0002". Element was owing to in Poland, not Plates - I will do affair including this companionship ended again.MT2 - 3/8" End powder landowner, "A" Style - including Trail End
- Richard Baker
The end mill holder facility as I had hoped. Very nice product. Strong lasting. I am using the end mill holder on a Craftsman Drill Press.Monty
- Monty King
The aim mill holder arrived promptly, nicely-packaged, and in perfect affect up. Here was a trail of stain including oil on the peter out, keep for indeed no gray grease; it was equipped for aid including a hardly any seconds including a paper rub down.The go on-made known in the peter out itself and the tool as a total (measured at the pole of a 3/8" aim mill) is indistinguishable early including the intention of of my machinery (and most tooling, for including the intention of matter). Indeed within 0.0005".The fit screw (which engages including the flat exhaust in your aim mill) is generous and is a skilled all fit in the corresponding fissure.The internal tolerances are accurate sufficient including the intention of they be inflicted including milled a small fissure in the side to allow air to being compensated away early as you insert your tool piece -- categorically no waggle opportunity at all.Agreed the fee, and high and mighty this is an import, it has exceeded my expectations. I cannot predict its roughness keep for, agreed the by and large feature and concentration to detail, I expect to get on to loads of being of skilled benefit made known of this tool.
- A. Blate
MT2 - 3/8" End Mill Holder, "A" Style - with Tang End
Owing to of alloy copied steel pro lingering, lasting benefit go. * Hardened to RC 56-60 and disturb a curfew to get on to guaranteed most suitability. * Holders are pro dual aim mills.
Comments
Post a Comment